Briquette press ball machine equipment production finished shape irregularities appear ball non-standard symptoms manifested finished ball surface is not smooth, or the finished product ball strong enough, which does not affect the standard of the finished productivity and production quality of enterprises, to avoid user excessive economic losses, today's Li Gongyi Tengda Machinery Plant engineers explain the pressure ball machine equipment ball non-standard problem. Coal briquetting machine equipment briquette press ball machine ball that is strong enough not standard phenomenon appeared because the spacing between the two pressure rollers excessive generated when the two roll spacing is too large, in the production pressure molding is not transmitted to the central portion of the finished balls, the material will fall off, this will result in the finished product ball burrs, surface is not smooth phenomenon, then we need to re-adjust the gap between the two pressure ball machine press roll clockwise Screw the screw under the pressure on the wedges so that the rolls are moved inward, so that you can achieve the purpose of adjustment, if the screw fixed, they can open before and after the host of plug, so you can use a pry bar pry inward oblique iron, so that you can lower lever clockwise twist, view the roll gap, the gap can be verified before the beam link bolt, so that you can replace the plug. But also pay attention to the gap between the two pressure rollers is not too small, the gap is too small, two-roll run dead, can not rotate properly, will reduce the service life of roll paper. When the roller ball coal briquetting machine nest center platen on both the control is not a mechanical displacement into a ball, when the ball will result in non-standard, leading to the finished surface of the ball is slightly burrs, when the ball severe dislocation it leads to pressure the ball finished substandard, then we only need to adjust the two pairs of rollers, and adjusting both roll paper bearing, the bearing and roller ball in the center of the control, so that coal briquetting machine is not pushed out of the ball there will be a flash. Specific adjustment method is as follows: It should be noted that loosening the bolts to adjust the disk, so you can use the top wire adjustment plate while being able to make the roll activity, this is also in order to eliminate backlash, the introduction of the top wire, rotating passive rolls to be able to make the ball on the positive, in doing this work when it should be noted that the positive direction of rotation of the gear, and check the ball has reached two rolls is on purpose, did not arrive at this time if the ideal state, to re-adjust, so that appropriate adjustments can post fastening bolt. Product technology content, technical performance, reliability and maintenance costs are in many aspects of the industry-leading level. We look forward to this your choice, and it is always ready to provide you with the most dedicated service. Address: Industry Zone in Wenxian Fuk Road and Main Street intersection Wu Jingli in industry: 15837116733 Tel: 0391-3705003 QQ: 403728776 slag pressure ball machine http://www.hnhuayijq.com coal briquetting machine www .hyyqj.com pressure ball machine www.hyyqj.com