When aerated concrete block equipment companies in autoclaved brick production, in order to make the use of autoclaved brick building performance to meet the requirements, you must put the brick on the saturated vapor pressure of the container must conserve some time, due to conservation to consume large amounts of steam, so autoclave curing autoclaved brick production section became part of the largest energy consuming a towel in order to seriously implement the national energy conservation policy, the company has attached great importance to how to make the exhaust inside the autoclave autoclave curing after completion steam. First, the exhaust steam in the transition to the autoclave temperature was about to heat body, raise the temperature inside the reactor in order to reduce the amount of steam boiler feed, kettle conversion balance after more than steam, and then used to give about warming autoclave heating or heating boiler feed water, domestic water and heating, etc. Make full use of exhaust steam heat to achieve the purpose of energy conservation. Did not raise the energy saving potential of steam section of digging to do. Tak Wai contrast autoclaved brick business, its energy consumption is only 1700000 kcal autoclave curing ten thousand (BiaoMei 242.86 kg), while the energy consumption of autoclaved brick autoclave curing average 3 150 000 kcal / ten thousand (equivalent to standard Coal 450 kg), a difference of about 1.85 times, indicating that there is great potential to be tapped. This paper therefore discharged from the autoclave can be implemented condensate dissipating heat and autoclave two aspects of the energy saving potential autoclave curing process. Due to the pressure of saturated steam autoclave is used as the carrier medium heat load of wet work, so in autoclave steam curing body process steam will continue to put their transfer heat to the body is heating up, autoclave vessel wall and car, etc., so that their temperature rises from surface to the desired temperature, and the vapor due to its temperature falls and becomes below 100 ℃ condensate, gradually accumulate in the bottoms condensate if not discharged outside the tank, will not only result in the kettle temperature difference between the upper and lower body produces too great ambassador kettle destructive "banana effect" and make conservation products out "cooked", but also to make the bottoms were chemical corrosion, it requires anywhere emissions condensate autoclave. Then every two autoclave curing one-pot brick condensate will be discharged too much, according to the information reported: Germany diameter 2 m, a length of 21m, working pressure of 16 bar (1 har = 0.987 rgf / cm :) autoclaved autoclave, autoclave curing every time emissions of condensate water were tested. When the entire autoclave curing, the heating phase started sending steam per hour, about 1000 L condensate produced, before reaching the allowable operating pressure, the maximum production of condensate water up to 4500 L. In the heated stage, as long as the reactor body good thermal insulation, condensing water production per hour only 50 L or less. Address: Industry Zone in Wenxian Fuk Road and Main Street intersection Wu Jingli in industry: 15837116733 Tel: 0391-3705003 QQ: 403728776 aerated concrete equipment http://www.huayijq.com aerated concrete equipment industry knowledge http : //www.huayijq.com/hangyezhishi.html digestion digestion warehouse _ _ warehouse storage silos http://www.huayijq.com/Product/82.html dual-beam two-speed driving electric double girder overhead crane _ http: //www.huayijq.com/Product/91.html